ISO 10931-5:1998 pdf download – Plastics piping systems for industrialapplications – Poly(vinylidene fluoride)(PVDF)— Part 5: Fitness for purpose of the system.
This part of ISO 10931 specifies the requirements for the fitness for purpose of piping systems made from poly(vinyfidene fluoride) (PVDF) for industrial applications, i.e. the conveyance of water and chemicals in the liquid or gaseous state. It also specifies the test parameters for the test methods referred to in this part of ISO 10931.
It is applicable to PVDF assemblies for the conveyance of fluids under pressure at temperatures up to ISO C. However. applications above 120 C. which depend on the crystalline melting point of the PVDF matenal, need to verified with the suppliers of the components
NOTE — For information on the resistance of PVDF materials in contact with diemicals. see ISG’TR 10356:1993, PYastics pipes and fittings — Cornblned chemical-resistance ctassifacation table
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this part of ISO 10931 At the time of publication, the editions indicated were valid, All standards are subject to revision, and parties to agreements based on this part of ISO lO93lare encouraged to investigate the possibility of applying the most recent edeions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards
ISO 1167:1996. Thermoplast,cs pqes for The conveyance of fluids — Resistance to internal pressure — Test method.
ISO 3458:1976, Assembled joints between fittings and polyethylene (PE) pressure pipes — Test of leakp.rootness under internal pressure.
1S03459:1976, Polyethylene (PE) pressure ppes — Joints assembled itth mechanical fittings — Internal under- pressure test method and requrrements.
ISO 10931-1:1997, Plastics piping systems for industezal applications — Po4’(wnyfldene fluoride) (PVDF) — Part 1: General.
3 DefinitIons
For the purposes of this part of ISO 10931 the definitions, symbols and abbreviations given in ISO 10931-1 apply.
4 Fitness for purpose of assembly
When tested in accordance with the test methods specified in table 1 or 2, as applicable, using the parameters indicated, the assembly shall conform to the requirements specified.