ISO 6362-4:2012 pdf download – Wrought aluminium and aluminiumalloys – Extruded rods/bars, tubes and profiles — Part 4: Profiles —Tolerances on shape and dimensions.
This part of ISO 6362 specifies the tolerances on dimensions and shape of wrought aluminium and aluminium alloy extruded profiles With a cross-section contained within a circumscribing circle not greater Than 800 mm.
This part of ISO 6362 applies to extruded profiles for general engineedng applications only.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 6362.1, Wrought aluminium and aluminium alloys — Extruded rods/bars, tubes and profiles — Part 1:
Technical conditions for inspection and delivery
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 6362-1 apply.
4 Materials
For the purposes of this part of ISO 6382, wrought aluminium and aluminium alloys are divided into two groups. which correspond to varying difficuLty when manufacturing the products.
The division into Group I and Group II of the most commonly used general engineering alloys is specified in Tables 1 and 2.