ISO 8675:1999 pdf download – Hexagon thin nuts (chamfered) with metricfine pitch thread- Product grades A and B
ISO 8675:1999 pdf download – Hexagon thin nuts (chamfered) with metricfine pitch thread- Product grades A and B.
ISO 8675 specifies the characteristics of hexagon thin nuts (chamfered), with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 64 mm, with product grade A for sizes d up to and including 16mm and product grade B for sizes dover 16mm.
If. in special cases. specifications other than those listed in this International Standard are required. they should be selected from existing International Standards, for example ISO 724, ISO 898-6, 150965-i, ISO 3506-2 and ISO 4159-1.
Coarse thread hexagon nuts according to ISO 4035 should be the first choice.
2 NormatIve references
The toltowing normative documents contain provisions wDich. througri reference in mis text, constitute provisions of this International Standar& For dated references, subsequent amendments to. or revisions of. any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards.
150225:1983, Fasteners — Bolts, screws, studs and nuts — Symbols and designations of dimensions. ISO 724:1993, ISO general-purpose metric screw threads — Basic dimensions.
ISO 898-6:1994, Mechanical properties of fasteners — Part 6: Nuts with specified proof load values — Fine pitch thread,
ISO 965-1:1998. Iso general purpose metric screw threads — Tolerances — Part I: Principles and basic data.
ISO 3269:—”. Fasteners — Acceptance inspection.
ISO 3506-2:1997, Mechanical properties of corrosion-resistant stainless-steel fasteners — Pad 2: Nuts.
1S04042:1999, Fasteners — Electroplated coatings.
ISO 4759-1 Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts — Product grades A, B and C.
ISO 6157-2:1995, Fasteners — Surface discontinuities — Part 2: Nuts.
IS08839:1986, Mechanical properties of fasteners — Bolts, screws, studs and nuts made of non-ferrous metals.