ISO 9692-2:1998 pdf download – Welding and allied processes – – Joint preparation一 Part 2: Submerged arc welding of steels.
This part of ISO 9692 applIes to typs of joint preparation let submerged arc welding with one wire electrode (process 121 accordIng to ISO 4063) on steel.
The part of ISO 9692 covers only the welding positions PA and PB according to ISO 6947. In case is used, special preparation will be necessary.
It applies to hilly penetrated welds. For partly penetrated welds, types of joint preparation, shapes and dimensions may differ from the listed proposals if they are specified in the relevant application standard or agreed by parties concerned.
It the root Is welded by a different arc welding process (see ISO 4063), he joint preparation according to ISO 9692 should be taken Into account.
2 Normahve refences
The following standards contain provisions which, through reference in this test, constitute ptovieaons of this International Stanard. At the time of publication, the editions Indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possiblity of applying the most recent editions of the standards listed below Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 2553 1992, Welded, brezd and soldered joints — Symbolic representation on drawings.
ISO 3834-1 1994, Ouahry requirements fet welding — Fusion welding of metallic materials — Patti: Guidelines icr selection and use.
ISO 3834-2: 1994. Quality requirements fo welding — Fusjon welding of metallic materials — Part Z Comprehensive quality requirements.
ISO 3834-3:1994. Quality requirements for welding — Fusion welding of metallic materials — Part 3. Standards quality requirements.
ISO 3834-4: 1994. Quality requirements let welding — Fusion welding of metallic materials — Part 4: Elementary quality requirements.
ISO 4O63:, Welding and allied processes — Nomenclature of processes and reference numbers. ISO 6947:1990. Wekis — Woi*Ingposti’ons — Definitions of angles of slope and rotation.
ISO 9692. 1992, Metal-arc welding with covered electrode, gas-shielded metal arc welding and gas welding — Joint
preparations for steel.
ISO 9956-2:1995 and Amd. Specification and approval of welding procedures for metallic materials — Part 2:
Welding procedure specification for al-c welding.
3 Motedcds
Joint preparations recommended In this part of ISO 9692 are suetable for all types of weldable steel.
4 Types d )olnt peporahon
The recommended types of joint preparation and dimensions are specified in tables 1 and 2.
The root gaps referred to in this part of ISO 9892 are those gaps presented after tack welding. If used.
This pert of ISO 9892 gives no dimensions or type of possibly used backing materials. Root runs may also be used as backing, They may influence the quality requirements for welding (according to th, relevant pail of ISO 38341 and the preparation as given in tables 1 arid 2. They shall be part of the welding procedure specIfication according to ISO
9956-2
According to the applkation standard or agreement between contracting parties, it nay be necessary to grind the slag before welding the next run
NOTE — The reference numbers have been determined in accordance with the following scheme:
The first digit corresponds to the number of the table; the second digit or numerical group corresponds to the number ri ISO 2553; the third Indication, expressed by a letter, takes into account the variants of joint preparations.