ISO 6099:2009 pdf downlaod – Fluid power systems and components —Cylinders – ldentification code for mounting dimensions and mounting types.
ISO 6099 establishes a convention for the identification of mounting dimensions and types used ii the mounting of fluid power c)Iinders. II specifies a code for identifying cinder mounting, envelope. accessory and connector dimensions, and for cylinder mounting and accessory types.
This International Standard does not represent a standard list of all fluid power cylinder mounting and accessory types.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5598. Flu,d power systems and components — Vocabuey
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 5598 apply.
4 Identification code for rod end types
4.1 Reference points and letter codes
4.1.1 General
4.1.1.1 First point of reference
Axial dimensions are determined from a reference point that is the same for all cylinders, whatever thew mounting method. This theoretical reference point (TRP) is the point of force transfer from the piston rod to the movable element This point of reference (TRP) is named the first TRP,
4.1.1.2 Second point of reference
For double rod cylinders, the second TRP is defined by the letter code ZM directly attached to the first point of TRP (see Figure 8). This second TRP is used for accessories on the second rod side.