ISO 8735:1997 pdf download – Parallel pins with internal thread,of hardened steel and martensitic stainless steel.
ISO 8735 specifies the characteristics of parallel pins with internal thread of steel, throughhardened or case hardened and martensitic stainless steel, with nominal diameters d, from 6 mm to 50 mminclusive.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of thisInternational Standard.At the time of publication, the editions indicated were valid.All standards are subjectto revision, and parties to agreements based on this International Standard are encouraged to investigate thepossibility of applying the most recent editions of the standards indicated below.Members of lEC and lSomaintain registers of currently valid lnternational Standards.
ISO 965-2:-“,IS0 general purpose metric screw threads – Tolerances – Part 2: Limits of sizes for generalpurpose bolt and nut threacs – Medium quality.
ISO 3269:1988, Fasteners – Acceptance inspection.
ISO 3506-1:1997,Corrosion-resistant stainless steel fasteners – Part 1:Bolts, screws and studs.IsO 4042:-. Fasteners – Electroplated coatings.