ASME B30.26-2004 pdf – Rigging Hardware
ASME B30.26-2004 pdf – Rigging Hardware. (b) Conditions such as those listed in para. 26-4.8.4, or any other condition that may result in a hazard, shall cause the hardware to be removed from service. Links, rings, and swivels shall not...
ASME B30.23-2005 pdf – Personnel Lifting Systems
ASME B30.23-2005 pdf – Personnel Lifting Systems. (4) verify that the hoisting equipment is set up and maintained within 1% of level during a personnel lift. (5) for hoisting equipment with a boom-attached platform, verify that the platform is attached...
ASME B30.20-2006 pdf – Below-the-Hook Lifting Devices
ASME B30.20-2006 pdf – Below-the-Hook Lifting Devices. (a) Adjustments shall be maintained to assure correct functioning of components. (b) Repairs or replacements shall be made as needed. SECTION 20-2.4: OPERATION 20-2.4.1 Operators Below-the-hook lifting devices shall be operated only by...
ASME B30.13-2003 pdf – STORAGE/RETRIEVAL (S/R) MACHINES AND ASSOCIATED EQUIPMENT
ASME B30.13-2003 pdf – STORAGE/RETRIEVAL (S/R) MACHINES AND ASSOCIATED EQUIPMENT. g) electrical apparatus, such as an emergency stop button, shall be functionally tested (h) overspeed sensors, loss-of-support detection mechanisms, and stopping mechanisms shall be functionally tested (i) other items as...
ASME B30.2-2011 pdf – Overhead and Gantry Cranes (Top Running Bridge, Single or Multiple Girder, Top Running Trolley Hoist)
ASME B30.2-2011 pdf – Overhead and Gantry Cranes (Top Running Bridge, Single or Multiple Girder, Top Running Trolley Hoist). (b) Equipment shall be inspected at intervals dependent on the use of the equipment as follows: (l) normal service — yearly...
ASME B30.28-2015 pdf – Balance Lifting Units
ASME B30.28-2015 pdf – Balance Lifting Units. (d) Socketing shall be done in a manner recommended by the rope or fitting manufacturer or a qualified person. (e) The rope ends shall he attached to the balancer in a manner to...
ASME B30.26-2010 pdf – Rigging Hardware
ASME B30.26-2010 pdf – Rigging Hardware. This Chapter applies to compression hardware, including forged wire rope clips and wedge sockets. SECTION 26-3.1: TYPES, MATERIALS, AND ASSEMBLY 26-3.1.1 Types (a) Wire rope clip types covered are U-bolt and double saddle (see...
ASME B30.25-2003 pdf – SCRAP AND MATERIAL HANDLERS
ASME B30.25-2003 pdf – SCRAP AND MATERIAL HANDLERS. (d) Means shall be provided for fastening outrigger floats to outriggers when in use. 25-1.7.5 RaiL-Mounted Handlers (a) Truck Wedges or lacks. Rail-mounted handlers shall be provided with removable wedges or jacks...
ASME B30.23-2016 pdf – Personnel Lifting Systems
ASME B30.23-2016 pdf – Personnel Lifting Systems. (d) the personnel lift authorizer to only authorize personnel lifting over, under, or in the vicinity of power lines, in accordance with the requirements of Mandatory Appendix I. (e) personnel platforms not to...
ASME B30.22-2000 pdf – ARTICULATING BOOM CRANES
ASME B30.22-2000 pdf – ARTICULATING BOOM CRANES. (b) A positive locking device or boom support shill be provided to prevent the boom from rotating when in slowed position for transit. Section 22.1.4: Crane Transport Commercial truck vehicle-mounted cranes shall meet...